BEKO DFS1500 DISHWASHER _ DISASSEMBLY INSTRUCTIONS [1]

DRAIN HOSE
[1]  Position of Drain Hose during the assembley of product.
[2] Position of Drain and Water Supply hoses before disassembling.

For the purpose of avoiding any siphonage in the drain hose, the hose is kept at a certain sufficient level by means of 1 hose clamp. This clamp should never be removed while assembling the machine in the desired position.

When the hose is to be replaced, the unit, which is seen at the right back top corner of the machine is required to be removed after being cut.

3 wire clamps and 2 plastic hose clamps are removed for dismantling the drain hose.

TOP PLATE

• Manner of opening the latch of the upper plate.

• Disassembly of top plate after the screws are dismantled.

• The plate is pulled back for approximately 1 cm. by unscrewing the bolts that are located at both sides of the upper plate in upward direction. Afterwards, the plate is removed by pulling it upwards.

TOP PLATE MID SUPPORT
The part can be dissembled by loosening 2 snops screw driver.

LOCK GROUP

• Door lock is mounted to the control panel by shown two snap fits.

BOTTOM TRAY
While providing service to the components located beneath the machine, the machine is moved to a place other than the place of installation.

• For dismantling the tray, the machine is inclined backwards with an angle of approximately 40°.

• The door is swiftly opened and the plastic cover located at the bottom of the machine is taken out, by being rotated in the downward direction without using any tool. Afterwards when this plastic cover is re-positioned  the similar procedure is applied but this time by being rotated in the reverse direction.
• 4 screws holding the base and located on the front side are removed and the components beneath the machine are accessed. Thus, it is possible to work on all the components except for the Water Inlet Valve, Clip Holder and the Drain Hose.

OVERFLOW GAUGE

• The mechanism attaching the overflow gauge to the base is pulled to the front direction, by pressing the latches and then is taken out.  NTC is taken out by being rotated 30°.

HEATER

• Pipe type heater is used in the machine. It is taken out by unscrewing the two spring clamps.

CIRCULATION PUMP

• Circulation pump is connected to the motor by snap fits shown.
• After the clamps and cable connections of the circulation pump are removed, the screws of the motor holding plate connected to the body frame are unscrewed. So as to detach the circulation pump from the motor holding plate, the connection is cut off by breaking the white coloured auricle shown in the photo, and a new auricle is installed during the assembly.